1 Safety Instructions User Manual
WARNING
• Check the positive and negative polarity of the PV strings, and connect the PV
connectors to corresponding terminals only after ensuring polarity correctness.
• During the installation and operation of the inverter, please ensure that the positive
or negative poles of PV strings do not short-circuit to the ground. Otherwise, an
AC or DC short-circuit may occur, resulting in equipment damage. The damage
caused by this is not covered by the warranty.
NOTICE
Comply with the safety instructions related to PV strings and the regulations related
to the local grid.
1.4 Operation Safety
DANGER
When routing cables, ensure a distance of at least 30 mm between the cables and
heat-generating components or areas to protect the insulation layer of cables from
aging and damage.
When the product is working:
• Do not touch the product enclosure.
• It is strictly forbidden to plug and unplug any connector on the inverter.
• Do not touch any wiring terminal of the inverter. Otherwise, electric shock may
occur.
• Do not disassemble any parts of the inverter. Otherwise, electric shock may occur.
• It is strictly forbidden to touch any hot parts of the inverter (such as the heat sink).
Otherwise, it may cause burns.
• Do not connect or remove any PV string or any PV module in a string. Otherwise,
electric shock may occur.
• If the inverter is equipped with a DC switch, do not operate it. Otherwise, it may
cause device damage or personal injury.
4
To Next Page
Need help?
General
