ENGINE 3-85
CRANKSHAFT THRUST CLEARANCE
ADJUSTMENT
• With the crankshaft’s right-side and left-side thrust bearings
inserted into the upper crankcase, measure the thrust clear-
ance between the left-side thrust bearing and the crankshaft
using the thickness gauge.
R: Right-side thrust bearing
L: Left-side thrust bearing
A: Front side
NOTE:
Pull
1
the crankshaft to the left so that there is no clearance on
the right-side thrust bearing.
# Crankshaft thrust clearance
Standard: 0.04 – 0.08 mm (0.0016 – 0.0031 in)
If the thrust clearance exceeds the standard range, adjust the
thrust clearance as follows:
• Remove the right-side thrust bearing and measure its thick-
ness using the micrometer. If the thickness of the right-side
thrust bearing is below standard, replace it with a new bearing
and measure the thrust clearance again, as described above.
# Right-side thrust bearing thickness
Standard: 2.42 – 2.44 mm (0.0953 – 0.0961 in)
• If the right-side thrust bearing is within the standard range, re-
insert the right-side thrust bearing and remove the left-side
thrust bearing.
• With the left-side thrust bearing removed, measure the clear-
ance using the thickness gauge as shown. Then, select a left-
side thrust bearing from the selection table. ($3-86)
To Next Page
Loading...
Need help?
General
