3-8 ENGINE
ENGINE REINSTALLATION
Reinstall the engine in the reverse order of engine removal.
• Insert the two long bolts from left side. Install the brackets, spacer, bolts and nuts properly, as shown in
the following illustration.
NOTE:
The engine mounting nuts are self-locking. Once the nuts have been removed, they are no longer of any
use. Be sure to use new nuts and tighten them to the specified torque.
NOTE:
When reusing the removed engine mounting bolts (
4
,
5
and
6
), apply a small quantity of the THREAD LOCK
“1342” to their threads.
#99000-32050: THREAD LOCK “1342”
Only for E-28 model; The engine mounting brackets
B
,
bolts
9
and bolts
0
are not equipped at the frame down
tubes.
LENGTH
Bolt 1, 2 35 mm (1.4 in)
Bolt 3 33 mm (1.3 in)
Bolt 4 55 mm (2.2 in)
Bolt 5 180 mm (7.1 in)
Bolt 6 132 mm (5.2 in)
Bolt 7 50 mm (2.0 in)
Bolt 8 30 mm (1.2 in)
Bolt 9 75 mm (3.0 in)
Bolt 0 25 mm (1.0 in)
Spacer RH A 27 mm (1.1 in)
"
ITEM N
.
m kgf
.
m lb-ft
1, 2, 3 50 5.0 36.0
4, 9 55 5.5 40.0
5, 6 88 8.8 63.5
7, 0 23 2.3 16.5
8 70 7.0 50.5
To Next Page
Loading...
Need help?
General
