2-10 PERIODIC MAINTENANCE
OIL FILTER REPLACEMENT
• Drain the engine oil as described in the engine oil replace-
ment procedure.
• Remove the oil filter 1 using the special tool.
• Apply engine oil lightly to the O-ring of the new oil filter, before
installation.
• Install the new oil filter. Turn it by hand until you feel that the oil
filter O-ring has contacted the oil filter mounting surface. Then,
tighten the oil filter two full turns using the special tool.
& 09915-40610: Oil filter wrench
NOTE:
To properly tighten the oil filter, use the special tool. Never tighten
the oil filter by hand.
• Add new engine oil and check the oil level as described in the
engine oil replacement procedure.
% NECESSARY AMOUNT OF ENGINE OIL
Oil change: 3.3 L (3.5/2.9 US/Imp qt)
Oil and filter change: 3.5 L (3.7/3.1 US/Imp qt)
Engine overhaul: 4.6 L (4.9/4.0 US/Imp qt)
'
ONLY USE A GENUINE SUZUKI MOTORCYCLE OIL FIL-
TER.
Other manufacturer’s oil filters may differ in thread speci-
fications (thread diameter and pitch), filtering perfor-
mance and durability which may lead to engine damage
or oil leaks. Also, do not use a genuine Suzuki automo-
bile oil filter on this motorcycle.
FUEL HOSE
Inspect every 6 000 km (4 000 miles, 6 months).
Replace every 4 years.
• Remove the seat.
• Remove the fuel tank mounting bolts. ($4-3)
• Lift up the fuel tank.
Inspect the fuel hose 1 for damage and fuel leakage. If any de-
fects are found, the fuel hose must be replaced.
After contacting the
gasket, tighten 2
turns.
To Next Page
Loading...
Need help?
General
