5-10 CHASSIS
• Remove the bearing using the special tool.
% 09921-20220: Bearing remover set
#
* The removed bearings should be replaced with new
ones.
* Do not stress the brake discs by using wooden block
under the wheel.
FRONT AXLE
Measure the front axle runout using the dial gauge.
If the runout exceeds the service limit, replace the front axle.
% 09900-20606: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
09900-21304: V-block set (100 mm)
$ Wheel axle runout
Service Limit: 0.25 mm (0.010 in)
REASSEMBLY
• Apply SUZUKI SUPER GREASE “A” to the bearings before
installation.
For USA
& 99000-25030: SUZUKI SUPER GREASE “A”
For the other countries
& 99000-25010: SUZUKI SUPER GREASE “A”
• Install the wheel bearings using the used bearings and special
tool as described 5-8 page.
% 09924-84510: Bearing installer set
#
First install the left wheel bearing, then install the right
wheel bearing. (
!!
!!
! 5-8)
The sealed cover on the bearing must face to the
outside.
To Next Page
Loading...
Need help?
General
