FUEL SYSTEM AND THROTTLE BODY 5-21
THROTTLE BODY INSTALLATION
Installation is in the reverse order of removal. Pay attention to
the following points:
• Connect the fuel injector couplers to the fuel injectors. Make
sure that each coupler is installed in the correct position. The
color on each lead wire refers to the appropriate fuel injector.
• Connect the throttle pulling cable 3 and throttle returning
cable 4 to the throttle cable drum.
• Loosen each throttle cable lock-nut.
• Turn in each throttle cable adjuster fully and locate each outer
cable so that the clearance is 0 mm (0 in).
• Tighten each lock-nut.
• Adjust the throttle cable play.
Refer to page 2-15 for details.
1 Primary injector 2 Secondary injector
#1 Y/R and Gr/W Y/R and Lg
#2 Y/R and Gr/B Y/R and Lg/W
#3 Y/R and Gr/Y Y/R and Lg/G
#4 Y/R and Gr/R Y/R and Lg/Bl
0 mm (0 in)
0 mm (0 in)
SAMPLE
To Next Page
Loading...
Need help?
General
