8-60 CHASSIS
• Assemble the cushion rod onto the swingarm temporarily.
NOTE:
The stamped marks A on the cushion rod should be face out-
side.
• Remount the chain cases 1 chain buffer 2 and rear fender
3.
INSTALLATION
Install the swingarm in the reverse order of disassembly and
removal, and pay attention to the following points.
SWINGARM PIVOT THRUST CLEARANCE ADJUSTMENT
Adjust swingarm pivot thrust clearance in the following procedure.
• Insert the swingarm pivot shaft and tighten to the specified
torque.
09944-28320: Hexagon socket (19 mm)
Swingarm pivot shaft: 15 N·m (1.5 kgf-m, 11.0 lb-ft)
• Hold the swingarm pivot shaft and tighten the swingarm pivot
nut 1 to the specified torque.
Swingarm pivot nut: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
• Tighten the swingarm pivot lock-nut to the specified torque
with the special tool.
09940-14940: Swingarm pivot thrust adjuster socket
wrench
Swingarm pivot lock-nut: 90 N·m (9.0 kgf-m, 65.0 lb-ft)
SAMPLE
To Next Page
Loading...
Need help?
General
