ELECTRICAL SYSTEM 9-41
NOTE:
If no air bubbles are coming up from a filler port, tap the bottom
of the electrolyte container two or three times.
Never remove the container from the battery.
• After confirming that the electrolyte has entered the battery
completely, remove the electrolyte containers from the bat-
tery. Wait for about 20 minutes.
• Insert the caps 6 into the filler holes, pressing in firmly so that
the top of the caps do not protrude above the upper surface of
the battery’s top cover.

For initial charging, use the charger specially designed for MF battery.

* Never use anything except the specified battery.
* Once the caps have been installed to the battery, do
not remove the caps.
* Do not tap the caps with a tool such as hammer
when installing them.
CORRECT
INCORRECT
* For charging the battery, make sure to use the charger specially designed for MF battery. Other-
wise, the battery may be overcharged resulting in shortened service life.
* Do not remove the cap during charging.
* Position the battery with the cap facing upward during charging.
SAMPLE
To Next Page
Loading...
Need help?
General
