72
(Continued)
MQA decoding
“MQA Decoding”
An MQA file or stream needs to be decoded to
deliver the master quality audio. Switch the MQA
decoding function to “On” or “Off”. (⇒ 42)
• The factory default is “Off”.
Disabling audio output
“Digital Output”/ “Analog Output”
Disabling the audio output of unused terminals
minimises noise and allows playback in higher audio
quality.
• The factory default is “On”.
• Set “Digital Output” to “Off” to disable the digital
audio output.
• Set “Analog Output” to “Off” to disable the
analogue audio output.
Setting the sampling frequency
“D.Output fs”
You can set an upper limit on the output sampling
frequency range. Please note that the range that
can be processed differs depending on the amplifier
with digital input terminal. For details, refer to the
operating instructions of the connected device.
• The factory default is “32kHz-192kHz”.
• Set “Digital Output” to “On” to use this function.
• 96 kHz or 192 kHz can be set as the upper limit on
the output sampling frequency range.
Setting the analogue audio output
“A.Output Level”
You can set the analogue audio output level is fixed
or adjustable when changing the volume with this
unit. (⇒ 25)
• The factory default is “Fixed”.
• The factory default of the analogue audio output
level is “-60.0 dB” when setting to “Variable”.
• -- dB (min), -99.0 dB to 0 dB (max)
• Set “Analog Output” to “On” to use this function.
To Next Page
Loading...
Need help?
General
