Operating Basics
2-16
370B User Manual
Figure 2–6 shows the STEP GENERATOR controls.
!
Figure 2-6: Step Generator Controls
The following STEP GENERATOR controls are available:
STEP AMPLITUDE. The STEP AMPLITUDE control sets the amplitude of the
generated steps. The step amplitude ranges from 50 nA to 200 mA per step in
current output mode and from 50 mV to 2 V per step in voltage output mode in a
1–2–5 sequence.
STEP MULTI. 1X. The STEP MULTI.1X control reduces the step signal amplitude
by a factor of ten without affecting the offset amplitude. The indicator above the
STEP MULTI . 1 X button lights when the Step Multi function is enabled.
Step Generator Controls
To Next Page
Loading...
General