Preparing the Meter for Operation
Turning Power-On 2
2-7
1. Verify that the line voltage selector block is set to the correct setting.
2. Verify that the correct fuse for the line voltage is installed.
3. Connect the power cord to a properly grounded three-prong outlet. Refer to Table
2-2 for descriptions of the line-power cord types available from Tektronix.
Table 2-2. Line-Power Cord Types Available from Tektronix
Type Voltage/Current Tektronix Part Number
North America 120 V / 15 A 161-0066-00
North America 250 V / 10 A 161-0066-12
Universal Euro 250 V / 10 A 161-0066-09
United Kingdom 250 V / 10 A 161-0066-10
Switzerland 250 V / 10 A 161-0154-00
Australia 250 V / 10 A 161-0066-13
Japan 125V / 7A 161-0298-00
China 250V / 10A 161-0304-00
Turning Power-On
XW Warning
To avoid electric shock, connect the Meter’s power cord to a
power receptacle with proper earth ground. A protective ground
connection by way of the grounding conductor in the power
cord is essential for safe operation.
With the proper line voltage selected and the appropriate power cord connected to the
Meter, connect the power cord to a power outlet and switch rear-panel power switch so
the “I” side of the switch is depressed.
Adjusting the Bail
For bench-top use, the Meter’s bail or handle is adjustable to provide two viewing angles.
To adjust its position, pull the ends out to a hard stop (about 1/4-inch on each side) and
rotate it to one of the four stop positions shown in Figure 2-3. To completely remove the
handle, adjust it to the vertical stop position and pull the ends all the way out.
To Next Page
Loading...
Need help?
General
