Front-Panel Operation
Controlling System-Related Operations 3
3-25
3. Press the soft key under VERSIONS + SN under the Setup menu.
The display shows the outguard software version (OutG SW), the inguard software
version (InG SW), the outguard hardware version (OutG HW) and the inguard
hardware version (InG HW). Also displayed is the Meter’s serial number
(Serial #).
Adjusting Display Brightness
Setting the brightness of the display is accessible through the Instrument Setup key.
To adjust display brightness:
1. Press I.
2. Press the SYSTEM soft key.
3. Press the BRIGHT soft key.
4. Press one of the soft keys under LOW, MEDIUM, and HIGH.
5. Press B to return to the previous menu.
Setting the Meter’s Date and Time
1. Press I.
2. Press the SYSTEM soft key.
3. Press the DATE TIME soft key.
4. To adjust the display to the desired date and time, press either <-- or --> to select
a specific digit or the month.
With the desired digit or month selected, press the soft key labeled -- to decrement
the digit or ++ to increment the digit.
5. Press the ENTER soft key to set the date and time and return to the system menu.
USB Operation
The USB memory operation offers a variety of capabilities. As an example, a USB device
can be used to store readings either directly from the A/D or by transferring readings
from internal memory. The data stored in the USB memory device is in a comma
delimited (CSV) format.
USB Storage Capacity and Write Time
The USB storage limit is 50,000 readings every time START is pressed (F1 soft key
press). Previous versions stored 50,000 readings in 10 files, each with 5,000 readings.
This version stores 50,000 readings in five files, with 10,000 readings each.
If storing readings to the USB memory device is not completed (or is interrupted by
changing function, NPLC, remote...), press MEMORY, MANAGE MEMORY,
INIT MEAS TO USB so volatile readings in internal memory are stored to the USB.
If STOP is selected during storage to the USB device, readings in internal memory will
be written directly to the device. Note that this may take several seconds. A USB memory
device should never be removed while a write is occurring.
The data is initially stored in internal memory and then transferred to the USB memory
device. For large data samples (i.e. > 10,000 readings), when 10,000 readings have been
stored in the internal memory, the data will be transferred to the USB memory device.
To Next Page
Loading...
Need help?
General
