Front-Panel Operation
Controlling Trigger Functions 3
3-21
Storing Meter Configuration Information
Up to five meter configurations can be stored in the Meter’s internal memory. An
additional 99 configurations can be stored in the external memory with optional USB
memory installed.
To store a meter configuration in the Meter’s internal memory:
1. Press M.
2. Press the STORE CONFIG soft key as shown below.
F1 F2 F3 F4 F5
0.5993
+
caw033.eps
3. Press the STORE INT MEM soft key.
4. Press one of the five soft keys labeled with the desired memory location to store the
present Meter configuration.
To store a meter configuration in to optional external memory:
1. Press M.
2. Press the STORE CONFIG soft key.
3. Press the STORE USB soft key.
The Meter labels the first four soft keys with the first four memory locations.
CONFIG01 through CONFIG04. The fifth soft key is labeled MORE to allow
access to all 100 memory locations.
4. To store the present Meter configuration in one of the first four memory locations,
press the appropriate soft key. If you want to store the present Meter configuration in
a location other than the first four locations, press the MORE soft key.
The display indicates the next available memory location. If all configuration
memory locations are filled, the Meter will always indicate memory location 10.
5. To adjust the display to the desired memory location, press either <-- or --> to
select a specific digit.
With the digit selected, press the soft key labeled -- to decrement the digit or ++ to
increment the digit.
6. With the preferred memory location set, press the ENTER soft key to store the Meter
configuration.
To Next Page
Loading...
Need help?
General
