23
4.3 Serve as a WiFi extender
If you have a router which is connected to the internet and want to extend the WiFi coverage, you
can refer to this chapter.
Assume that the information of your existing WiFi network is as follows:
− WiFi name: My_home_WiFi
− WiFi password: TendaAC947
Method 1: Set the router to WISP mode
Configuring procedures:
Step 1 Start a web browser on a device connected to the router and visit tendawifi.com to log in
to the web UI of the router.
If you use the router for the first time or have reset router, proceed with the following steps. If you
have already configured the router, skip Step 2.
Step 2 Set Connection Type to Dynamic IP Address, and click OK. You will be direct to the Status
page.
To Next Page
Loading...
Need help?
General
