Backlapping the Cutting Units (continued)
Finishing Backlapping
1. Move the Lower Mow/Raise lever rearward and disengage the PTO.
2. Shut off the engine and remove the key.
3. Move the backlap levers to the F (mow) position.
IMPORTANT
If you do not change backlap lever to the F (mow) position after backlapping, the
cutting units will not function properly.
G417040
Backlap lever (mow position—front cutting units)
Backlap lever (mow position—rear cutting units)
4. Lower and latch the operator’s seat.
5. Wash all lapping compound off from the cutting units.
6. For a better cutting edge, run a file across the front face of the bedknife after lapping.
Note: This removes any burrs or rough edges that may have built up on the cutting
edge.
Chassis Maintenance
Inspecting the Seat Belt
1. Inspect the seat belt for wear, cuts, and other damage. Replace the seat belt(s) if any
component does not operate properly.
2. Clean the seat belt as necessary.
3464-482A Page 6–41 Maintenance: Cutting Unit Maintenance
To Next Page
Loading...
Need help?
General
