Overview of the Warm-Up Mode
When starting the machine in cold weather, warm-up mode limits the engine speed to low
idle for a short period after the engine is started, preventing potential component damage
from operating the machine with cold oil.
A snowflake icon on the display screen denotes when warm-up mode is active. Do not
operate the machine until after the warm-up period.
Overview of Toro Smart Power™
With Smart Power, the operator does not have to listen to the engine speed in heavy load
conditions. Smart Power prevents the engine from bogging down in heavy cutting conditions
by automatically controlling the machine speed and optimizing cutting performance.
Note: By default, the Smart Power feature is ON.
Starting the Engine
IMPORTANT
The fuel system automatically bleeds itself before starting the engine if you are
starting the engine for the first time, the engine has shut off due to lack of fuel, or you
have performed maintenance on the fuel system.
1. Sit on the seat, keep your foot off the traction pedal so that it is in N
EUTRAL, engage the
parking brake, and ensure that the PTO switch is not engaged.
2. Turn the key to the O
N/PREHEAT position.
An automatic timer controls the glow plug preheat for 6 seconds.
3. After preheating the glow plugs, turn the key to the S
TART position.
Note: Crank the engine for no longer than 15 seconds. Release the key when the
engine starts. If additional preheating is required, turn the key to the O
FF position and
then to the O
N/PREHEAT position. Repeat this process as required.
4. Run the engine at low idle speed until it warms up.
Shutting Off the Engine
1. Move all controls to NEUTRAL, engage the parking brake, and allow the engine to reach
low idle speed.
2. Turn the key to the O
FF position and remove it from the switch.
3464-482A Page 5–19 Operation: During Operation
To Next Page
Loading...
Need help?
General
