Cleaning the Fuel-Pickup Tube Screen (continued)
G415056
6. Plug the connector of the fuel-sender harness
into the connector of the machine wire
harness
.
G415055
7. Install the fuel-sender cover to the fuel tank
using the 5 screws .
Priming the Fuel System
Prime the fuel system after the following scenarios:
• Replacing the fuel filter.
• Draining the water separator after each use or daily.
• Running out of fuel.
• Replacing a fuel hose or open the fuel system for any reason.
To prime the fuel system, perform the following steps:
IMPORTANT
Do not use the engine-starter motor to crank the engine for fuel-system priming.
1. Ensure that fuel is in the fuel tank.
2. Perform the following steps to prime the filter and the lines to the high-pressure pump to
prevent wear or damage to the pump:
A. Cycle the ignition key to the O
N position for 15 to 20 seconds.
Maintenance: Fuel System Maintenance Page 6–25 3464-478 A
To Next Page
Loading...
Need help?
General
