Slope Safety (continued)
– Remove or mark obstructions such as ditches, holes, ruts, bumps, rocks, or other
hidden hazards. Tall grass can hide obstructions. Uneven terrain could overturn the
machine.
– Be aware that operating the machine on wet grass, across slopes, or downhill may
cause the machine to lose traction.
– Use extreme caution when operating the machine near drop-offs, ditches,
embankments, water hazards, or other hazards. The machine could suddenly roll
over if a wheel goes over the edge or the edge caves in. Establish a safety area
between the machine and any hazard.
– Identify hazards at the base of the slope. If there are hazards, mow the slope with a
pedestrian-controlled machine.
– If possible, keep the cutting units lowered to the ground while operating on slopes.
Raising the cutting units while operating on slopes can cause the machine to become
unstable.
After Operation Safety
• Park the machine on a level surface.
• Disengage and lower the cutting units
• Engage the parking brake.
• Shut off the engine and remove the key.
• Wait for all movement to stop.
• Allow the machine to cool before adjusting, servicing, cleaning, or storing it.
• To help prevent fires, ensure that the cutting units, drives, mufflers, cooling screens, and
engine compartment are free from grass and debris buildup. Clean up oil or fuel spills.
• Disengage the drive to the attachment whenever you are hauling or not using the
machine.
• Maintain and clean the seat belt(s) as necessary.
• Do not store the machine or fuel container where there is an open flame, spark, or pilot
light, such as on a water heater or on other appliances.
Maintenance Safety
• Before you leave the operator’s position, do the following:
– Park the machine on a level surface.
– Disengage and lower the cutting units.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all movement to stop.
– Allow the machine to cool before adjusting, servicing, cleaning, or storing it.
3464-478A Page 2–4 Safety: After Operation Safety
To Next Page
Loading...
Need help?
General
