Installing the Rear Cutting Units to the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch) or Higher Height of Cut
G402695
1. Install the rear cutting units to the lift arms as
shown.
2. Lock the cutting-unit pivot for cutting grass on
a hill side.
Installing the Rear Cutting Units to the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch) or Lower Height of Cut
G402723
1. Remove the lynch pin and washer
securing the to the pivot yoke to the lift arm
, and slide the shaft out of the lift arm.
G402724
2. Assemble the pivot yoke onto the carrier
frame shaft
.
3. Assemble the cap
to the pivot yoke, and
align the holes in the carrier frame shaft, pivot
yoke, and cap.
4. Secure the pivot yoke and cap to the carrier
frame shaft with the snapper pin
.
5. Lock the cutting-unit pivot for cutting grass on
a hill side.
6. Slide a cutting unit under the lift arm.
G402725
7. Insert the pivot yoke into the lift arm , and
secure the lift-arm shaft
to the lift arm with
the lynch pin
and washer .
8. Repeat this procedure for the other rear cutting
unit.
3464-478A Page 3–6 Setup: Installing the Cutting Units
To Next Page
Loading...
Need help?
General
