160
Troubleshooting
Remote control problems
Remove all obstructions between the remote control and the TV.
Replace the remote control’s batteries, see “Installing batteries” on page
47.
Your TV’s remote control may not operate certain features on your
external device. Refer to the owner’s manual for your other device to
determine its available features. If your TV remote control does not
operateaspecicfeatureonanotherdevice,usetheremotecontrolthat
came with the device, see “Learning about the remote control” on page
50.
If the TV still does not act as expected, perform the Reset Factory
Defaults procedure, see “Resetting to Factory Defaults” on page 87.
Channel tuning problems
Ensure that the remote control is set to the correct device mode, see
“Learning about the remote control” on page 50.
The Auto Tuning feature may have erased the channel from memory. To
add the channel to the channel memory, see “Manual Tuning” on page
67.
Ifyoucannottunedigitalchannels,checktheantennaconguration,see
“Initial setup” on page 52. If the problem persists, clear all channels
from the channel list and reprogram channels into memory, see “Storing
channels in memory (optional)” on page 66. For additional information,
see “TV stops responding to controls.” on page 157. If the problem
persists, use the Reset Factory Defaults procedure, see “Resetting to
Factory Defaults” on page 87.
Remote control problems
To Next Page
Loading...
Need help?
General