Introduction
21
3 Do not plug in any power cords until after you have connected all
cables and devices to your TV.
4 Before connecting cables or devices to the TV, review the functions
of the TV’s connections and controls, see “Overview of cable types”
on page 26.
5 Connect your other electronic device(s) to the TV, see “Connecting
Your TV” on page 26.
6 Install the batteries in the remote control, see “Installing batteries”
on page 47.
7 See “Using the Remote Control” on page 47 for an overview of
the buttons on the remote control.
8 After connecting all cables and devices, plug in the power cords for
your TV and other devices. Then press the POWER button on the
TV control panel or remote control to turn on the TV.
NOTE: If the TV stops responding to the buttons on the remote
control or TV control panel and you cannot turn the TV off or on,
unplug the power cords for a few seconds and then plug them in and
try again.
9 See “Navigating the menu system” on page 62 for a quick
overview of navigating the TV’s menu system.
10 Program channels into the TV’s channel memory, see “Auto
Tuning” on page 66.
11 For details on using the TV’s features, see chapters 6, 7, and 8.
12 For help, refer to “Troubleshooting” on page 157.
13 Fortechnicalspecications,see“Specications”onpage166.
TV front and side panel controls and connections
Power LED
Remote sensor
Ambient light sensor
2 USB ports
1 Analog
Video port
ARC HDMI
®
only port
3 HDMI
®
ports
1 Digital
Audio jack
TV front and side panel controls and connections
To Next Page
Loading...
Need help?
General