53
Setting up your TV
Setting the time zone
2 Highlight Installation, and then press the ENTER button.
A new set of Installation menu icons appears.
3 Open the Terrestrial menu, highlight Signal Meter, and then
press the ENTER button.
4 Press the (/// arrow) buttons to select the antenna input
and digital channel signal you wish to check.
❖ The physical digital channel number listed in the Signal Meter
screen may not correspond to a virtual TV channel number.
Contact your local broadcasters to obtain the RF channel
numbers for your local digital stations.
❖ The signal strength does not change between virtual channels on
the same physical channel.
To close the screen and return to the Terrestrial menu:
❖ Highlight Done, and then press the ENTER button.
To return to normal viewing, press the EXIT button.
Setting the time zone
The Time Zone setup allows you to specify the correct time zone
for your region. This feature allows the TV status information to
display the correct time zone information for your viewing area.
To set the time zone:
1 In the Setup menu, highlight Installation, and then press the
ENTER button.
2 Highlight Time Zone, and then press the ENTER button.
3 Press the ( / arrow) buttons to select the region, highlight
Done, and then press the ENTER button.
After the time zone has been set, you will be asked to set the current
Daylight Saving Time status.
To set the Daylight Saving Time status:
❖ Press the ( / arrow) buttons to select Yes or No, highlight
Done, and then press the ENTER button.
Viewing the system status
1 Press the MENU button and open the Setup menu.
2 Highlight Installation, and then press the ENTER button.
A new set of Installation menu icons appears.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
