E6582175
F-138
6
6.38 Communication function
6.38.1 Setting of communication function
f800 : Baud rate f814 : Communication command
f801 : Parity point 2 frequency
f802 : Inverter number f829 : Selection of communication
f803 : Communication time-out time protocol
f804 : Communication time-out action f856 : Number of motor poles for
f805 : Communication waiting time communication
f806 : Setting of master and slave for f870 : Block write data 1
communication between inverters f871 : Block write data 2
f808 : Communication time-out f875 : Block read data 1
detection condition f876 : Block read data 2
f810 :
Communication command point selection
f877 : Block read data 3
f811 :
Communication command point 1 setting
f878 : Block read data 4
f812 :
Communication command point 1 frequency
f879 : Block read data 5
f813 :
Communication command point 2 setting
f899 : Communication function
reset
Warning
Mandatory
action
Set the parameter Communication time-out time (f803) , Communication time-out action (f804)
and
Disconnection detection of extension panel (f731).
If these are not properly set, the inverter cannot be stopped immediately in breaking communication and
this could result in injury and accidents.
An emergency stop device and the interlock that fit with system specifications must be installed.
If these are not properly installed, the inverter cannot be stopped immediately and this could result in
injury and accidents.
Refer to “Communication Function Instruction Manual : E6581913” for details.
To Next Page
Loading...
Need help?
General