E6582175
K-46
11
11.8 Application easy setting
When 1 to 7 is set by parameter aua (Application easy setting), the parameters of the table below are set to
parameter f751 to f782 (Easy setting mode parameter 1 to 32).
Parameter f751 to f782 are displayed at easy setting mode.
Refer to section 4.2 about easy setting mode.
aua
1: Initial easy
setting
2:
Conveyor
3: Material
handling
4: Hoisting 5: Fan 6: Pump
7:
Compressor
f751 cmod cmod cmod cmod cmod cmod cmod
f752 fmod fmod fmod fmod fmod fmod fmod
f753 acc acc acc acc acc acc acc
f754 dec dec dec dec dec dec dec
f755 ul ul ul ul fh fh fh
f756 ll ll ll ll ul ul ul
f757 thr thr thr thr ll ll ll
f758 fm fm fm fm thr thr thr
f759 - pt pt pt fm fm fm
f760 - olm olm olm pt pt pt
f761 - sr1 sr1 f304 f201 f201 f216
f762 - sr2 sr2 f308 f202 f202 f217
f763 - sr3 sr3 f309 f203 f203 f218
f764 - sr4 sr4 f328 f204 f204 f219
f765 - sr5 sr5 f329 f207 f207 fpid
f766 - sr6 sr6 f330 f216 f216 f359
f767 - sr7 sr7 f331 f217 f217 f360
f768 - f201 f240 f332 f218 f218 f361
f769 - f202 f243 f333 f219 f219 f362
f770 - f203 f250 f334 f295 f295 f363
f771 - f204 f251 f340 f301 f301 f366
f772 - f240 f252 f341 f302 f302 f367
f773 - f243 f304 f345 f303 f303 f368
f774 - f250 f308 f346 f633 f610 f369
f775 - f251 f309 f347 f667 f611 f372
f776 - f252 f502 f400 f668 f612 f373
f777 - f304 f506 f405 - f633 f380
f778 - f308 f507 f415 - f667 f389
f779 - f309 f701 f417 - f668 f391
f780 - f701 - f648 - - f621
f781 f701 f702 - f701 - - -
f782 psel psel psel psel psel psel psel
To Next Page
Loading...
Need help?
General