UNI-T UTD4000 Series User Manual

UTD4000 Four-channel
User Manual
60
Instructions :
Press [ to go to the type menu. There
are three types to choose from : Setting, Wave,
Bitmap.
1. Select Wave to go to the waveform storage
menu shown below (see Table 2-2 ). A stored
reference waveform can be recalled with the REF
menu (reference waveform, P 32). For specific
steps see the REF instructions.
Table 2-20 Storage Menu
:
About Internal and CSV formats : When
exporting a reference waveform to the USB
device you can select internal or CSV.
Internal waveforms can only be imported to the
oscilloscope in REF mode and cannot be displayed
on any other interface. CSV waveforms can be
opened in EXCE
L on a PC. It is a group of
voltage and time correlation 2D data.
STORAGE
Note
]
,
" "
0
“ ” “ ”
“ ”
“ ”
Function Menu
Setup
Explanatory Note
Type
Select a signal source waveform displayed on the screen
Wave
Source
Select waveform from CH1
Select waveform from CH2
Select waveform from CH3
Select waveform from CH4
CH1
CH2
CH3
CH4
Save
To save the reference waveform on the internal memory of the
oscilloscope, turn the control knob to select
the storage position and press the control
knob to confirm
MULTIPURPOSE
MULTIPURPOSE
1~10
----
Export
Go to the USB menu
See Table 2-21

UNI-T UTD4000 Series Specifications

General

Brand	UNI-T
Model	UTD4000 Series
Category	Test Equipment
Language	English