Getting to Know the Trigger System
As shown in Figure there are one knob and
one button in the trigger menu control zone. The
following steps will get you familiar with trigger setup.
When operating edge, pulse width and slew rate
triggers, set the amplitude to be crossed by the
waveform upon signal occurrence by turning the
trigger knob To quickly set the trigger
level as the vertical centre point of the trigger
signal press the trigger knob
To display trigger menu contents
1. Use the trigger knob to change the
trigger level You will see a trigger sign on the
screen that indicates the trigger level The sign
nd down with the knob While you
move the trigger level you will find the trigger
level value on the screen changing accordingly.
2. Open the trigger [ ] key (see the figure 1 )
Press [ ] twice and select for
To Next Page
Loading...
Need help?
General
