Illustration 8 : Using the dual time base function
In the dual time base mode, you can enjoy unrivaled
detailed observation of a waveform For example
you can observe the colour Burst signal of the
video signal clear observation is impossible with
1. To access video signal in CH1, follow the Video
line trigger instructions in Illustration 7 : Video
2. Press [ ] in the horizontal control zone to
display the time base setup menu.
3. Press [ ] to enter dual time base setup.
4. Press [ ] to select dual time base, then press
[ ] to select CH1. Press [ ] to set time base
graticule to M1 Adjust the M time base range
3 13 Then press to select M2 and
adjust the M2 time base range with the
knob as shown in Figure 3 13
5. Shift the M2 time base with the
control knob to show the parts you require to
observe in detail When shifting M2 press
to choose coarse or fine tune to shift in
Figure 3-13 Dual time base function
To Next Page
Loading...
Need help?
General
