Press [CURSOR] to display the measurement cursor
and cursor menu, then adjust the cursor position by
turning the control knob As
shown in the figure below in the
control zone is the function key for cursor
You can move the cursor to carry out measurement in
the [ ] mode. There are two modes to choose
from : voltage and time. When measuring voltage,
select voltage for type and adjust the positions of
the two cursors with the control
knob to measure V. Likewise, by selecting time you
can measure T. The [ ] menu has two other
modes : independent and tracking In the
independent mode you can adju
the two cursors independently In the tracking
mode you press the control knob
to move two cursors simultaneously
1. In the independent or tracking mode, select one of
the cursors with the control knob
The selected cursor is a solid line. Adjust its
position with the control knob
2. There are two percentage options. The current
status is 100%. The value between the two
cursors is set to 100% i e one cursor is 0%
and the other is 100% When 100% is set to 6
DIV the 3DIV area on the screen is 100%.
3. When the cursor function is enabled, measurement
value is automatically displayed in the
corner. @ is the selected cursor value.
Figure 2-27 Function key for the sampling
To Next Page
Loading...
Need help?
General
