Chapter 3 Practical Example
Illustration 1 : Measuring simple signals
1. To quickly display this signal, follow the
2. Voltage and time parameters for automatic
To observe and measure an unknown signal, and to
quickly display and measure the signal s frequency
In the probe menu, set the attenuation factor to
10X and set the switch on the probe to 10X.
Connect the CH3 probe to the circuitry point to be
The oscilloscope will carry out auto setup to
optimise waveform display. In this status, you can
further adjust the vertical and horizontal range
until you get the desired waveform display.
Your oscilloscope can automatically measure
most display signals. To measure signal
frequency and peak-to-peak value, f
Press [ ] to display the automatic
Press [ ] to enter the measurement type
Use the control knob to select
peak to peak value then press it down to
confirm Next use the control
knob to select frequency then press it down to
Press [ ] to exit the selection
To Next Page
Loading...
Need help?
General
