Note Automatic measurement of voltage parameters
Customised parameters are for quick parameter
measurement. The measurement menu of your
oscilloscope is capable of measuring 26 waveform
parameters. Two of them (delay and phase for
advance measurement) are generally used when you
do not require to measure all parameters but only a
few. You can set these as customized parameters.
Customized parameters are displayed on the screen.
Your UTD4000 Series Oscilloscope
can automatically measure the following voltage
Peak-to-peak value (Vpp) : The voltage value from the
highest point to lowest point of the waveform.
lue (Vmax) : The voltage value from the
highest point to ground (GND) of the waveform.
Minimum value Vmin The voltage value from
the lowest point to ground GND of the waveform
Amplitude value (Vamp) : The voltage value from top
Mean (Vmid) Half of the amplitude value.
Top value (Vtop) : The voltage value from the level top
to ground (GND) of the waveform.
Base value (Vbase) : The voltage value from the level
base to ground (GND) of the waveform.
Overshoot : The ratio value of the difference between
maximum value and top value to the amplitude value.
Figure 2-27 Measurement parameters
To Next Page
Loading...
Need help?
General
