10 Getting started
Getting started
Contents of the package
• One handset,
• One battery cover (rear cover of handset),
• One battery,
• One belt clip,
• One user guide.
Installing the charging cradle
The charging cradle is designed for operation in closed, dry rooms within a temperature range of +5 °C to
+45 °C.
The phone's feet do not usually leave any marks on surfaces. However, due to the multitude of different
varnishes and polishes used on today's furnishings, the occurrence of marks on the surfaces cannot be
completely ruled out.
Connecting the charger
¤ Connect the flat plug of the AC adapter .
¤ Insert the AC adapter into the power socket .
To remove the plug from the charging cradle again:
¤ Disconnect the AC adapter from the mains power supply.
¤ Press the release button .
¤ Pull out the plug .
Setting up the handset for use
The display is protected by a plastic film. Please remove
the protective film!
Inserting the battery
Never expose the telephone to the influence of heat sources, direct sunlight or other electrical
devices.
Protect the telephone from moisture, dust, corrosive liquids and fumes.
Only use a rechargeable battery as this could otherwise result in significant health risks and per-
sonal injury. For example, the outer casing of the batteries could be destroyed or the battery
could explode. The phone could also malfunction or be damaged as a result of using batteries
that are not of the recommended type.
¤ Insert battery with the contact surface facing
down .
¤ Then press the battery downwards until it
clicks into place .
¤ Align the protrusions on the side of the
battery cover with the notches on the
inside of the casing .
To Next Page
Loading...
Need help?
General