EasyManuals Logo
Home>Unify>IP Phone>OpenScape SL5

Unify OpenScape SL5 User Manual

Unify OpenScape SL5
101 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
Manufacturer's advice 39
Protecting our environment
Disposal
Batteries should not be disposed of in general household waste. Observe the local waste disposal regulations, details of
which can be obtained from your local authority. Dispose of batteries in the green boxes designated as "common collec-
tion system for batteries" at specialist retailers.
All electrical and electronic products should be disposed of separately from the municipal waste stream via designated
collection facilities appointed by the government or the local authorities.
This crossed-out wheeled bin symbol on the product means the product is covered by the European Directive
2002/96/EC.
The correct disposal and separate collection of your old appliance will help prevent potential negative conse-
quences for the environment and human health. It is a precondition for reuse and recycling of used electrical
and electronic equipment.
For more detailed information about disposal of your old appliance, please contact your local authority refuse center or
waste disposal service.
Care
Always use a damp or antistatic cloth to clean the device. Do not use solvents or microfiber cloths.
Never use a dry cloth as this can cause a static charge.
In rare cases, contact with chemical substances can cause changes to the device's exterior. Not all substances have been
tested due to the wide variety of chemical products available on the market.
Impairments to high-gloss finishes can be carefully removed using display polishes for mobile phones.
Contact with liquid
If the device comes into contact with liquid:
1. Disconnect it from the power supply.
2. Remove the batteries and leave the battery compartment open.
3. Allow the liquid to drain from the device.
4. Dab all components dry.
5. Place the handset in a dry, warm place for at least 72 hours with the battery compartment open and keypad (if appli-
cable) facing down (not in a microwave, oven, etc...).
6. Do not switch on the device again until it is completely dry.
When it has fully dried out, you will usually be able to use it again.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Unify OpenScape SL5 and is the answer not in the manual?

Unify OpenScape SL5 Specifications

General IconGeneral
BrandUnify
ModelOpenScape SL5
CategoryIP Phone
LanguageEnglish

Related product manuals