NOTICE
If any damage is observed on a robot within the warranty period, contact the
distributor where the robot was purchased.
3.1.3. Functional Inspection
Do functional inspections to ensure the robot arm and its screws, bolts and tools are not loose.
Use a correctly calibrated torque wrench and screwdrivers specified into check the screws and
bolts listed in the inspection plan.
For the robot arm mounting bolts specifications, see the Hardware Installation Manual, chapter
Mechanical Interface: Mounting.
3.1.4. Cleaning your robot
Everyday cleaning
You can wipe away any dust/dirt/oil observed on the robot arm and/or Teach Pendant using a
cloth and one of the following cleaning agents: Water, Isopropyl alcohol, 10% Ethanol alcohol or
10% Naphtha. In rare cases, very small amounts of grease can be visible from the joint. This does
not affect the function, use, or lifetime of the joint.
Additional cleaning
Due to the added focus on cleaning your robot, UniversalRobots recommends cleaning with 70%
isopropyl alcohol (rubbing alcohol).
1. Wipe the robot with a hard twisted micro fiber cloth and 70% isopropyl alcohol (rubbing
alcohol).
2. Let the 70% isopropyl alcohol dwell on the robot for 5 minutes, and then clean the robot
using standard cleaning procedure.
DONOTUSEBLEACH. Do not use bleach in any diluted cleaning solution.
3.2. Control Box and Teach Pendant
3.2.1. Inspection Plan
The table below is a checklist of the type of inspections recommended by Universal Robots. Per-
form inspections regularly as advised in the table. Any referenced parts found to be in an unac-
ceptable state must be rectified or replaced.
See the following sections for detailed guidance:
UR20 8 Service Manual
3.Recommended Inspection Activities
Copyright © 2009–2023 by UniversalRobotsA/S. All rights reserved.
To Next Page
Loading...
Need help?
General
