♦ Camshaft bar - T10068 A-
♦ Drip tray for workshop hoist - VAS 6208-
♦ Workshop hoist - VAS 6100-
♦ Lifting tackle - 3033-
♦ Pliers for spring-type clips - VAS 6499-
♦ Puller - T10095 A-
Not illustrated:
♦ Torque wrench - V.A.G 1331-
♦ Torque wrench - V.A.G 1332-
♦ Sealant - D 176 501 A1-
♦ Locking fluid - D 197 300 A2-
Conditions
• The engine must be no more than warm to touch.
Removing:
Caution
Observe the following during all assembly work, particularly in
the engine compartment due to the restricted space:
♦ Route lines of any kind and cables so that original routing
is restored.
♦ Ensure that there is sufficient clearance to all moving or
hot components.
Note
♦
All cable ties which were opened or cut during removal must
be renewed at the same locations.
♦
To prevent damage to removed components, place them in
the container for removed parts - V.A.G 1698- .
– Disconnect earth strap at battery with ignition switched off ⇒
Electrical system; Rep. gr. 27 ; Battery; Disconnecting and
connecting battery .
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
– Remove air filter ⇒ page 174 .
– Drain coolant ⇒ page 142 .
– Note safety precautions before starting further installation
work ⇒ page 4 .
– Observe rules for cleanliness ⇒ page 6 .
CC 2012 ➤ , Passat 2011 ➤ , Passat Variant 2011 ➤
6-cylinder direct-injection engine (3.6 l engine, 4V) - Edition 06.2019
1. Cylinder head 61
To Next Page
Loading...
Need help?
General
