❑ Gold-plated contacts on sensor and connector.
❑
Mark connector before removing.
11 - 10 Nm
12 - Hall sender 2 - G163-
❑ For exhaust camshaft
❑ Gold-plated contacts on sensor and connector.
13 - Sealing ring
❑ Renew
14 - Hall sender - G40-
❑ For inlet camshaft
❑ Gold-plated contacts on sensor and connector.
15 - Knock sensor 2 - G66-
❑ Fitting location: cylinder block intake side
❑ Gold-plated contacts on sensor and connector.
16 - Connector
❑ Black, 2-pin.
❑ Gold-plated contacts on sensor and connector.
17 - Inlet camshaft adjuster
❑ Identification: 24E
❑ With sender wheel for Hall sender - G40-
❑ Removing and installing
⇒ page 105
18 - Spark plug, 18 Nm
❑
Remove and install with spark plug socket and extension - 3122B-
❑ Type and electrode gap
⇒ page 215 .
19 - Valve timing housing
❑
For camshaft adjustment.
1.2 Removing and installing ignition coils
with output stage
Special tools and workshop equipment required
♦ Puller - T10095 A-
CC 2012 ➤ , Passat 2011 ➤ , Passat Variant 2011 ➤
6-cylinder direct-injection engine (3.6 l engine, 4V) - Edition 06.2019
1. Ignition system 213
To Next Page
Loading...
Need help?
General
