Volkswagen CC 2012 User Manual

– Install tensioner for timing chain -arrow-. Specified torque:
50 Nm.
– Remove camshaft bar - T10068 A- and tighten bolt of camshaft
adjuster. Specified torque: 60 Nm +
1
/
4
turn (90°) further.
Note
Only counterhold at camshaft with 27 mm open-end spanner
-arrow-. The camshaft bar - T10068 A- must not be fitted when
camshaft adjuster is loosened or tightened.
Further assembly is carried out in the reverse order of removal.
3.3 Removing and installing chain drive
sprocket for high-pressure pump
Removing:
– Remove high-pressure pump ⇒ page 195 .
– Remove camshaft adjuster for inlet camshaft -1-
⇒ page 108 .
– Undo and remove bolt -3- for guide rail.
– Remove timing chain from chain drive sprocket.
– Pull out bearing shaft -4- and remove chain drive sprocket
-6-.
Installing:
Note
Coat faces of chain drive sprocket and bearing shaft with lubri‐
cating paste - G 052 723 A2- .
CC 2012 ➤ , Passat 2011 ➤ , Passat Variant 2011 ➤
6-cylinder direct-injection engine (3.6 l engine, 4V) - Edition 06.2019
86 Rep. gr.15 - Cylinder head, valve gear

Volkswagen CC 2012 Specifications

General

Brand	Volkswagen
Model	CC 2012
Category	Automobile
Language	English