12 - Dowel pins
13 - Bolt
❑ 10 Nm
2.2 Removing and installing timing chain
cover
Special tools and workshop equipment required
♦ Hand drill with plastic brush
♦ Safety glasses
♦ Sealant - D 176 501 A1-
Removing:
– Removing gearbox ⇒ Rep. gr. 34 ; Removing and installing
gearbox .
– Remove flywheel ⇒ page 36 .
– Remove sump ⇒ page 125 .
– Remove bolts -1 and 2- for cover.
Caution
Avoid damage to cylinder head gasket. If the cylinder head
gasket is bent excessively, it can be kinked. A kinked cylinder
head gasket must be renewed.
– Pull off cover from cylinder block horizontally.
– Press crankshaft oil seal out of lower timing chain cover.
Installing:
• Specified torques ⇒ page 78 .
Caution
The lubrication system can be soiled by sealant residue. Care‐
fully cover open parts of engine so that no sealant residue can
fall into it.
– Remove remaining sealant on the timing chain cover and cyl‐
inder head using rotating plastic brush etc. Wear safety gog‐
gles.
– Clean sealing surfaces; they must be free of oil and grease.
CC 2012 ➤ , Passat 2011 ➤ , Passat Variant 2011 ➤
6-cylinder direct-injection engine (3.6 l engine, 4V) - Edition 06.2019
76 Rep. gr.15 - Cylinder head, valve gear
To Next Page
Loading...
Need help?
General
