Menu Function See
Assistants
Turn the Adaptive Front Lighting System (AFS) on and off
(if applicable).
Vehicle
status
Current warning and information messages.
This menu item is only displayed when warning or infor-
mation messages are available. The number of available
messages is shown in the display. Example: 1/1 or 2/2.
Settings
Includes the Convenience and Lights & Vision submenus,
as well as many settings such as time, speed warning for
winter tires, language, and units.
MFI menu (Multi-Function Indicator)
¤ Please first read and note the introductory information and heed the WARNINGS
The MFI display has 2 automatic memories: 1 – single trip memory and 2 – total trip memory. The
number of the trip memory is shown at the upper right of the display.
The trip memories are in addition to the trip odometer, which is displayed in the bottom part of the
instrument cluster and controlled using the E3%4 button on the right of the instrument panel ⇒ fig. 11
(4).
To display the distance driven on trips 1 and 2, select the Route item in the MFI menu. Press the
OK
button ⇒ fig. 15 to toggle between Route 1 and Route 2 (trip 1 and trip 2). Push and hold the
OK
button
to manually reset a trip memory to zero.
1
Single trip memory
The memory accumulates and stores information about distance driven
and fuel used from the time the ignition was switched on until the time it
was switched off.
If the ignition stays off for 2 hours or more, stored information is auto-
matically deleted. If the trip is continued within 2 hours after the ignition
was switched off, the new values are added.
2
Total trip memory
The memory displays and stores the accumulated driving and fuel con-
sumption data of any number of single trips up to a total driving time of
99 hours and 59 minutes, and up to a total distance of 9,999 miles
(9,999 km). If one of the maximum values is exceeded, then the memory
is automatically cleared and starts again from 0.
Possible MFI menu displays
The following displays can be accessed in the MFI menu if enabled under Settings > MFI data.
Displays that are not enabled will not appear.
Displa
Function
Travel time
Driving time in hours (h) and minutes (min) corresponding to trip memo-
ries 1 and 2 (toggle).
Consumption
--.- mpg
Current fuel consumption in miles per gallon (l/100 km) while driving.
When units are set to miles, dashes appear instead of a number when
the engine is running and the vehicle is standing still.
When units are set to kilometers, the display shows liters consumed per
hour when the engine is running and the vehicle is standing still.
Consumption
--.- l/100 km