Volkswagen EOS User Manual

Please carry out each step only in the order specified:
fig. 192 (1) (2) (3) (3)
Low beam Front turn signal
indicator
High beam
/
daytime running
light
Parking light (small bulb
holder)
4. Turn the bulb holder counterclockwise as far as it will go
and pull it out towards the rear together with the light
bulb.
Pull the bulb holder out
towards the rear along
with the light bulb.
5. Pull the light bulb straight out of the bulb holder.
If necessary, press the lock on the bulb holder.
6. Replace the burned out light bulb with a new bulb of the same type.
7. Insert the bulb holder into the headlight assembly and
turn clockwise as far as it goes.
Insert the bulb holder into
the headlight and slide it
in completely.
8.
Attach the rubber or plastic cover.
If applicable slide the securing clip rearward.
The illustrations show the left headlight assembly from the rear. The right headlight assembly is
the mirror image of the left headlight assembly.
Different models may have different lights, and the location and design of covers, bulb holders,
and bulbs may be in a different location than shown in the illustrations.
You cannot replace the LEDs in LED daytime running lights. Contact your authorized
Volkswagen dealer or an authorized Volkswagen Service Facility for assistance.
Replacing light bulbs in the front bumper
Fig. 193 In front right bumper: Removing the light assembly.

Volkswagen EOS Specifications

General

Brand	Volkswagen
Model	EOS
Category	Automobile
Language	English