Switching Anti-Slip Regulation (ASR) on and off
Fig. 133 In the center console: Button for switching ASR on and off manually.
¤ Please first read and note the introductory information and heed the WARNINGS
The Electronic Stability Control (ESC) only works when the engine is running. This system includes
ABS, EDL and ASR.
ASR can be switched off by pressingm⇒
fig. 133 while the engine is running. Switch off ASR only in
situations where there is not enough traction, such as the following:
x When driving in deep snow or on loose surfaces.
x When “rocking” the vehicle back and forth when you are stuck.
Afterward, activate ASR again by pressing the button m.
Brake fluid
Fig. 134 In the engine compartment: Brake fluid reservoir cap.
¤ Please first read and note the introductory information and heed the WARNINGS
Brake fluid absorbs water from the air over time. Too much water in the brake fluid will damage the
brake system. Water also lowers the boiling point of the brake fluid. Too much water in the brake fluid
can cause vapor lock during heavy brake use or hard braking. Vapor lock reduces braking
performance, increases stopping distances and can even cause total brake failure. Your safety and
the safety of others depends on brakes that are working properly at all times ⇒
.
To Next Page
Loading...
Need help?
General
