x Push on the cover at the bottom marking ⇒ fig. 198 (arrow) so that it pops out.
x Remove the cover and let it hang from the bumper.
x Screw the towing eye counterclockwise into the threaded hole as far as it will go (arrow)
⇒
fig. 199 ⇒ . Use the lug wrench to turn and tighten the towing eye.
x When towing is complete, unscrew the towing eye clockwise to remove it.
x Position the lower lip of the cover in the opening in the bumper and carefully push the upper lip
carefully over the edge of the opening.
x Push on the upper part of the cover until the lower lip has locked into place.
NOTICE
Always make sure the towing eye is screwed all the way into threaded hole so that it is secure.
If not, it could be pulled out while your vehicle is being towed.
Installing the rear towing eye
Fig. 200 In right rear bumper: Remove cover.
Fig. 201 On the right rear bumper: Screwed-in towing eye.
¤ Please first read and note the introductory information and heed the WARNINGS
There is another threaded hole for the towing eye in the right rear bumper ⇒ fig. 201.
To Next Page
Loading...
Need help?
General
