Removing
– Pull spray jet with cover cap -1- to stop out of bumper cover.
– Unclip cover cap -1- from mounting points -arrows- on spray
jet assembly.
– Lever locking lug -arrow- up slightly and pull out spray jet as‐
sembly.
Installing
Note
The degree to which the cover cap of the spray jet is pulled down
onto the bumper cover can be adjusted using the clips on the
spray jet assembly. If the spray jet assembly is not pulled in far
enough, the cover cap will not seat correctly. If the spray jet as‐
sembly is pulled in too far, the cover cap and the bumper cover
could be pushed out of shape.
– Push spray jet assembly into pop-up cylinder until it engages.
– Fit cover cap on spray jet assembly and allow pop-up cylinder
to retract.
– Check the cover cap is seated correctly on the bumper cover.
– If necessary, adjust seat of cover cap by pushing spray jet
assembly in higher or lower position on pop-up cylinder.
– On completion of installation work, bleed headlight washer
system ⇒ page 210 .
– Check headlight washer system spray jets and adjust if nec‐
essary ⇒ page 210 .
5.5 Adjusting headlight washer system
spray jets
⇒ Maintenance ; Booklet 20.1 ; Descriptions of work
5.6 Bleeding headlight washer system
To guarantee sound functioning of pop-up cylinders and spray
jets, the headlight washer system must be bled following assem‐
bly work or when operated for the first time.
WARNING
Apply handbrake and make sure that gearshift is set to „P“.
Procedure
– Fill washer fluid reservoir.
– Start the engine.
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Electrical system - Edition 07.2010
210 Rep. gr.92 - Windscreen wash/wipe system