9.8 Interior monitoring sensor -G273- (from
MY2010)
Note
♦
The anti-theft alarm sensor -G578- includes the vehicle incli‐
nation sender -G384- and the interior monitoring sensor -
G273- (two sensors).
♦
The anti-theft alarm sensor -G578- cannot be dismantled.
Removing and installing anti-theft alarm sensor -G578-
⇒ page 432 .
9.9 Central locking and anti-theft alarm sys‐
tem aerial -R47-
Up to MY2009
The central locking and anti-theft alarm system aerial -R47- is
routed from the convenience system central control unit -J393- to
the A-pillar on left in the main wiring harness.
The central locking and anti-theft alarm system aerial -R47- can‐
not be repaired as this would adversely affect the reception
quality.
In the event of damage, it is necessary to replace the central
locking and anti-theft alarm system aerial -R47- .
From MY2010
The central locking and anti-theft alarm system aerial -R47- re‐
ceives the signals from the remote control and passes them to
the onboard supply control unit -J519- .
The central locking and anti-theft alarm system aerial -R47- is
integrated in the onboard supply control unit -J519- and cannot
be replaced individually.
Additional information:
⇒ Current flow diagrams, Electrical fault finding and Fitting loca‐
tions
9.10 Removing and installing alarm horn -
H12-
The alarm horn -H12- is located on the right at the A-pillar in the
wing.
Special tools and workshop equipment required
♦ Drill -VAS 5134-
♦ Twist drill bit ∅ 6 mm
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Electrical system - Edition 07.2010
9. Anti-theft alarm (ATA) 435