– Degrease black sender head -1- in area to be painted -2- with
isopropanol (isopropyl alcohol).
– Paint sender in area to be painted -2- in colour of bumper cov‐
er.
Note
Dimension -B- for the painted area must not exceed 3 mm (plus
maximum 2 mm).
– Fit isolation ring (black silicone ring) on sender head again
once paint has dried.
Caution
♦ Expanding the isolation ring must be avoided under all
circumstances.
♦ Function problems may occur if a damaged isolation ring
is used.
♦ Renew damaged isolation rings.
14.13 Testing parking aid senders
This function can be used to check the following components via
the parking aid control unit -J446- :
♦ Front left parking aid sender -G255-
♦ Front centre left parking aid sender -G254-
♦ Front centre right parking aid sender -G253-
♦ Front right parking aid sender -G252-
♦ Rear left parking aid sender -G203-
♦ Rear centre left parking aid sender -G204-
♦ Rear centre right parking aid sender -G205-
♦ Rear right parking aid sender -G206-
Procedure
– Connect vehicle diagnosis, testing and information system -
VAS 5051B- .
– In vehicle diagnosis, testing and information system -VAS
5051B- , select „Guided fault finding“.
– Using GoTo button, select „Functions/component“ and the fol‐
lowing menu options in succession:
♦ Body
♦ General body repairs
♦ Parking aid
♦ Electrical components
♦ Parking aid senders
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Electrical system - Edition 07.2010
350 Rep. gr.94 - Lights, bulbs, switches - exterior