– Pull off connector -1-.
– Unscrew nuts -2- from tail light in lower part of side panel.
– Remove tail light.
Installing
Carry out installation in the reverse sequence, noting the follow‐
ing:
– Tighten all threaded connections to specified torques
⇒ page 309 .
Note
♦
Tail light connector in side panel must be „heard“ to engage
when reconnecting.
♦
Connector is locked correctly when locking tab is pressed
down again!
– When installation is complete, check gap/shut lines of tail light
to body.
9.6 Assembly overview - tail light in rear lid - saloon
1 - Nut
❑ 3.5 Nm
2 - Bulb carrier
❑ Removing and installing
⇒ page 311
3 - Left reversing light bulb -
M16- / left reversing light bulb
-L46- / right reversing light bulb
-M17-
❑ Bulb: P 12 V/21 W
4 - Tail light housing in rear lid
❑ Removing and installing
⇒ page 311
5 - Washer
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Electrical system - Edition 07.2010
310 Rep. gr.94 - Lights, bulbs, switches - exterior