10 Other components of auxiliary air
heater
⇒ “10.1 Function description of remote control”, page 59
10.1 Function description of remote control
Note
♦
The auxiliary/supplementary heater can be switched on and
off from a distance of several 100 metres (open space) using
the remote control. This range is restricted in built-up areas or
from within buildings.
♦
The remote control should be held upright when operating the
buttons (the radio signals can be received optimally by the ve‐
hicle aerial in this way and the greatest transmission range is
achieved).
♦
Following disconnection of the vehicle batteries, the auxiliary/
supplementary heater remote control does not have to be re-
adapted.
♦
If the remote control does not work properly, check the remote
control battery ⇒ page 60 .
♦
If the remote control is renewed, it must be adapted using
⇒ Vehicle diagnostic tester.
♦
Start guided fault finding or guided functions in ⇒ Vehicle di‐
agnostic tester, and then start “Adapt remote control”.
Switching on auxiliary/supplementary heater using remote control
– Press button -3-. The indicator lamp -1- must light up green.
When the auxiliary/supplementary heater is switched on, its op‐
erating time is determined by means of the setting on the multi‐
function display.
Switching off auxiliary/supplementary heater using remote control
– Press button -2-. The indicator lamp -1- must light up red.
The auxiliary heater switches to run-on mode and then switches
off.
Renewing remote control battery
Special tools and workshop equipment required
♦ Removal wedge - 3409-
Transporter 2020 ➤
Auxiliary heater - Edition 04.2020
10. Other components of auxiliary air heater 59
To Next Page
Loading...
Need help?
General
