♦ Line filling carried out
♦ On-board network manager not active
♦ No crash shut-off
♦ No event memory entries blocking start procedure
♦ Has been put into service
2.3 Rules for cleanliness when working on
auxiliary/supplementary heater and fuel
system
♦ Thoroughly clean all connections and adjacent areas before
disconnecting.
♦ Place removed parts on a clean surface, and cover them over.
Use only lint-free cloths.
♦ Carefully cover opened components or seal them if repairs
cannot be carried out immediately.
♦ Install only clean parts; do not remove new parts from pack‐
aging until immediately before installing. Do not use parts that
have been kept unpackaged (for example in toolboxes).
If the fuel system is open:
– Do not work with compressed air.
– Do not move the vehicle.
– Do not start the engine.
– Do not switch on auxiliary/supplementary heater.
2.4 Notes for vehicles with a start/stop sys‐
tem
Additional information:
♦ Refer to ⇒ Self-study programme No. 426 ; Start/Stop System
2009 for description of features.
Transporter 2020 ➤
Auxiliary heater - Edition 04.2020
2. General information 5
To Next Page
Loading...
Need help?
General
