Engine Shutdown
Stop the Engine
IMPORTANT:
Never disconnect the current using the main switches
when the engine is running or by disconnecting the
battery cables.
The alternator and electronics could be damaged.
IMPORTANT:
Make sure the ignition is turned off before the main
switches are switched off. Otherwise the alternator and
electronics could be damaged.
NOTICE! To let the engine control unit shut down
correctly, always turn ignition off before turning off
battery power to the engine. Wait 15 seconds after
turning ignition off before turning off battery power. Not
following this procedure can result in fault codes in the
displays.
Stopping Using the Start/Stop Panel
1 Disengage the drive/reverse gear by putting the
control lever in neutral.
2 Stop the engine(s) by pushing the START/STOP
button(s).
Stopping Using the e-Key
1 Disengage the drive/reverse gear by putting the
control lever in neutral.
2 Push the stop button(s). Release the button(s)
when the engine(s) has/have stopped.
3 Turn off the ignition and lock the EVC system
To turn the ignition of, press the IGNITION button.
The green lamp in the IGNITION button goes out to
indicate the ignition is off.
To lock the EVC system, hold the key fob in front of the
symbol on the e-Key panel.
A flashing red light indicates the system is locked.
47712786 11-2022 © AB VOLVO PENTA 99
To Next Page
Loading...
Need help?
General
