NOTICE! After
confirming Step 1,
Step 2 starts
automatically.
Set maximum thrust
force.
11. Hold the Joystick's
position for 10
seconds before
confirming: push
DOCKING.
(Determine the ratio
between the engine
and maximum thrust
force.)
12. Step 2: Docking
calibration started.
13.
NOTICE! Keep Joystick in its
outermost side position until
confirmation in step 16.
14. Balancing thruster power towards engine.
Compensate boat movements with the Joystick by
rotating knob and moving it forward-backward.
15. Adjust forward rpm: Higher value: push button
JOYSTICK DRIVING. Lower value: push button
THRUSTER on Joystick.
16. Balancing engine power towards thruster.
The boat must move straight abeam.
If not fulfilled, adjust to a higher engine rpm.
17. Hold the Joystick's
position for 5 seconds
before confirming:
push DOCKING
18. Steady light and buzzer
confirm completed calibration.
Ignition must be turned off for at
least 15 seconds to confirm the
calibration.
19. Test Drive.
To redo Step1 and/or Step
2: Start from the
beginning.
Calibration and Settings
47712786 11-2022 © AB VOLVO PENTA 151
To Next Page
Loading...
