102
Hydraulic cooling fan operation
Change oil and filter
Oil and filter should be changed every 120,000 km.
Fan drive oil is red.
1. Drain the oil through the drain hole in the bottom of the
oil reservoir.
2. Unscrew and scrap the old filter.
3. Moisten the new filter rubber gasket with oil. Screw on
the filter by hand until the gasket makes contact with the
sealing surface. Then, turn a further 1/2 to 3/4 of a revo-
lution.
4. Fill with oil to the top of the level glass.
5. Start the engine. Check the tightness around the filter.
6. Stop the engine, check the oil level and top up to the top
of the level glass if necessary.
Oil change volume
Approx. 33 l including oil filter.
Oil grades
ATF Dexron IID (Volvo part. no. 1161282 for 208 l package
and 1161934 for 20 l package).
Check oil level
The oil level should be in close to the top of the level glass.
Do not overfill!
Drain
Check
oil level
Oil reservoir for
hydraulic cooling fan
operation.
Oil filter
Service and Maintenance
Filling
To Next Page
Loading...
Need help?
General
